Ice-O-Matic 9161124-02 Condenser Fan Motor

What the Condenser Fan Motor Does

Your cooling unit creates heat as it operates. The condenser fan motor turns the fan blades to push outdoor air through the coil, which carries that heat away.

When this motor fails, heat cannot leave the unit. The system will quickly build up excess heat and shut down on thermal safety switches to prevent damage.

Understanding the 9161124-02 Specifications

Electrical and physical measurements must match your old part closely so it mounts correctly and operates safely. The 9161124-02 carries these exact specifications:

Voltage: 230V

Length: 6 in / 15.24 cm

Width: 6 in / 15.24 cm

Height: 4 in / 10.16 cm

A 230V rating means the motor is built for higher-voltage line power. Never connect a motor rated for 230V to a lower or higher voltage circuit.

How to Confirm a Match

Before replacing an old motor, review its physical tag and compare it against the required ratings. These key match rules apply:

HP: must be the same

RPM and volts: must be the same

Rotation and shaft: match, or pick a reversible motor

Also check the physical size against your existing bracket. The length of 6 in / 15.24 cm, width of 6 in / 15.24 cm, and height of 4 in / 10.16 cm must fit within the motor housing.

Troubleshooting and Safe Replacement

A fan that hums but will not spin is often a bad capacitor, not a bad motor. A capacitor costs less, so check it first. A new motor often needs a new capacitor rated for it.

When replacing the motor, follow these steps to keep the job organized and safe:

1. Turn off power at the main breaker and pull the outdoor disconnect.
2. Test all wires with a meter to verify that the power is fully off.
3. Take a photo of every wire before removing the old part so you have a wiring map.
4. Discharge the capacitor using an insulated tool before touching any of its terminals.
5. Loosen the mounting bolts and gently slide the fan blade assembly off the motor shaft.
6. Mount the replacement motor securely into the frame.
7. Move wires one at a time to the same spots on the new part, using your photo as a guide.

Read your old part

1. Locate the metal data tag stamped on the side or back of your existing motor.
2. Read the part number directly from the tag to verify it reads 9161124-02.
3. Check that the label specifies a 230V power rating.
4. Measure the motor body to confirm it matches 6 in / 15.24 cm length, 6 in / 15.24 cm width, and 4 in / 10.16 cm height.