Ice O Matic 9101084-01 Relay Reference Guide

What the Relay Does

A relay is a small switch run by an electric coil. When control power energizes the coil, it pulls internal contacts together or pushes them apart.

This action allows a lower-power control signal to safely switch power to other circuits inside your unit.

Understanding the 9101084-01 Specifications

Every electrical switch has distinct physical and electrical ratings. Make sure each rating matches what your system requires.

• Voltage: 120V
• Poles: 2 Pole
• Length: 1.5 in / 3.81 cm
• Width: 1.05 in / 2.67 cm
• Height: 0.9 in / 2.29 cm

How to Match a Replacement Relay

Matching a relay requires looking at the printed label on your old part and checking its electrical configuration.

Coil volts must be the same. The action must feature the same contacts, such as matching poles. Any amp rating must be the same or higher than the old part.

Safe Removal and Installation Steps

If a relay fails, its internal contacts can stick, burn, or fail to close when the coil receives voltage.

Follow these direct steps when swapping out an old relay:

1. Turn off electrical power at the main breaker.
2. Use a meter to test for power and verify the circuit is completely dead.
3. Take a clear photo of every wire connected to the old relay.
4. Disconnect the wires and move them one at a time to the same spots on the new part.
5. Secure the relay in place and restore power to test the unit.

Read your old part

1. Locate the identification sticker or stamp on your existing relay.
2. Check that the printed part number reads 9101084-01.
3. Confirm the coil voltage rating on the old part shows 120V.
4. Verify the old relay has a 2 Pole configuration.
5. Measure the mounting space to ensure it accommodates the dimensions of 1.5 in / 3.81 cm length, 1.05 in / 2.67 cm width, and 0.9 in / 2.29 cm height.