This part is out of stock right now, so it cannot be added to the cart.
When a control signal reaches the contactor coil, it pulls internal contacts closed. This allows higher-voltage electrical current to pass through the switch.
Specifications
- Part number: 34200332
- Brand: Rancilio
- Part type: Mini contactor
- Height: 2 in / 5.08 cm
- Length: 11 in / 27.94 cm
- Voltage: 220-240V
- Width: 9 in / 22.86 cm
- Poles: same count, 1 or 2
- Coil volts: must be the same, most homes use 24 V
- Amps: same or higher than your old one
From the maker's and parts sellers' listings for this number. Compare them with the label on your old part.
How a Mini Contactor Works
A contactor uses a low-power circuit to open and close a much heavier electrical load. When your system calls for operation, voltage is applied to the contactor coil.
The energized coil generates a magnetic pull that closes the contacts. Once closed, line power flows through the terminals to run equipment parts like motors or heating elements. When the demand ends, the coil releases and opens the contacts to cut power.
Understanding the 34200332 Specifications
Physical dimensions and electrical ratings must match your existing setup to ensure the component mounts cleanly and operates safely.
- Voltage: 220-240V
- Height: 2 in / 5.08 cm
- Length: 11 in / 27.94 cm
- Width: 9 in / 22.86 cm
Confirming a Matching Contactor
When finding a replacement switch, the electrical ratings and layout must match your original unit. Never install a contactor that cannot handle your system voltage or current requirements.
- Poles: must have the same count, 1 or 2.
- Coil volts: must be the same rating as your system controls.
- Amps: must be the same or higher than your old part.
Signs of Contactor Failure and Safe Replacement
Over time, electrical arcing can damage contact points. Common signs of wear include burnt or pitted contacts, an unusually loud buzzing sound, or equipment that fails to start or stop when called.
Always take precautions before handling any electrical part inside your unit.
- Turn off power completely at the main circuit breaker and any disconnect switch.
- Use a meter to test for power and verify all lines are dead before touching anything.
- Take a clear photo of every wire connection to remember the exact wiring layout.
- Move each wire one at a time to the matching terminal on the new contactor.
Read your old part
- Locate the identification sticker or stamped text on the body of your current contactor.
- Confirm the part number printed on your old switch reads 34200332.
- Check that the voltage rating on your part label matches 220-240V.
- Measure the physical space to ensure the 2 in / 5.08 cm height, 11 in / 27.94 cm length, and 9 in / 22.86 cm width fit the mount.
- Verify the number of poles matches your existing electrical setup.
When to call a pro
Line voltage wiring carries severe shock hazards. If you are uncomfortable working around 240 V, or if you are not sure you can complete the repair safely, hire a licensed technician.
Questions
What is the voltage rating for part 34200332?
This mini contactor is rated for 220-240V. Your replacement part must match the voltage requirements of your equipment.
What are the dimensions of this mini contactor?
The dimensions are 2 in / 5.08 cm in height, 11 in / 27.94 cm in length, and 9 in / 22.86 cm in width. Make sure your mounting bracket or space accommodates these dimensions.
What are common signs that a contactor needs replacement?
A worn contactor often exhibits burnt or pitted contacts. It may also emit a loud buzzing noise, or the equipment may fail to start or stop properly.
How should wires be moved to a new contactor?
Take a photo of every wire before removing anything. Then move the wires one at a time to the matching spots on the replacement switch.
Related part numbers
- 00-562597-00001Contactor, HobartSame part type
- 9101002-07Contactor Reference, Ice-O-MaticSame part type
- 42-25103-01Contactor, PROTECHSame part type
- 369178Contactor Reference, LincolnSame part type
Browse: Contactors by part number
All part numbers · Part number replacements · Shop contactors · Repair guides
Brand names and part numbers identify the part and show fit. HVAC Fitter is not affiliated with, authorized by, or endorsed by any equipment maker. If you are not sure a repair is safe for you, call a licensed HVAC technician.