Traulsen 338-60054-00 Condenser Fan Motor

What the Condenser Fan Motor Does

A condenser fan motor plays a vital role in cooling. It spins the fan blades to keep air flowing across the warm coils.

Without steady airflow, heat builds up quickly inside the cabinet. The system will overheat and shut down on thermal protection to prevent severe damage. Keeping this motor running smoothly is critical to normal operation.

Dimensions and Physical Specifications

Motor compartments can be tight. Checking physical measurements ensures the replacement fits inside the existing bracket and housing without rubbing against other components.

The recorded dimensions for part number 338-60054-00 are:

• Height: 4.45 in / 11.30 cm
• Length: 4.8 in / 12.19 cm
• Width: 4.5 in / 11.43 cm

How to Confirm a Replacement Matches

When selecting a replacement condenser fan motor, every key electrical and physical rating must align with the original part. Do not rely on appearance alone.

Use these standard matching rules to verify that another motor will work in place of the old one:

• HP: must be the same
• RPM and volts: must be the same
• Rotation and shaft: match, or pick a reversible motor

Signs of Failure and Safe Replacement

When a fan stops turning, do not assume the motor is dead right away. A fan that hums but will not spin is often a bad capacitor, not a bad motor. Because a capacitor costs less, check it first before removing the motor.

If the motor has failed, replace it carefully using these basic steps:

1. Shut off power at the breaker panel and pull the disconnect switch. Test for power to be sure it is dead.
2. Take a photo of every wire before disconnecting the old motor.
3. Loosen the mounting bracket and remove the fan blade from the shaft.
4. Mount the matching motor into the bracket and attach the fan blade securely.
5. Move wires one at a time to the same spots on the new part, using your photo as a guide.
6. Restore electrical power and test the unit to ensure the fan spins smoothly in the correct direction.

Read your old part

1. Wipe dust and dirt from the metal housing of your old motor to locate the printed manufacturer label.
2. Look for the exact part number 338-60054-00 on the nameplate.
3. Check the voltage, horsepower, and RPM ratings stamped on the label to verify they match your replacement requirements.
4. Measure the height, length, and width of your old motor frame to confirm it matches the 4.45 in by 4.8 in by 4.5 in dimensions.
5. Check the direction of shaft rotation to ensure the new motor moves air the right way.