Heil 1080612 Condenser Fan Motor

What the Condenser Fan Motor Does

Your central air conditioner moves heat out of your house and sends it outside. The condenser fan motor sits at the top of the outdoor cabinet, attached directly to the fan blades.

When the cooling cycle turns on, the motor spins the blades to pull outside air through the coil fins. Without proper airflow from the fan, heat builds up quickly in the system. The unit will then stop cooling and shut down to protect the components from severe heat damage.

Understanding the Specs for Heil 1080612

When you hold your old motor, its nameplate lists critical electrical and mechanical ratings. All replacement ratings must align properly to run safely and correctly.

The official ratings for part 1080612 include:

• Horsepower: 1/8 HP
• Voltage: 208-230 Vac
• Full Load Current: 0.57 Amps
• Speed: 1120 RPM
• Rotation: Counterclockwise (CCW)
• Frame Size: 42
• Phase: Single Phase

Matching a Replacement Motor

To ensure your equipment functions as intended, the replacement motor must meet exact standards. Using the wrong ratings can cause the motor to burn out or spin the fan backwards.

• HP: must be the same.
• RPM and volts: must be the same.
• Rotation and shaft: match, or pick a reversible motor.

Troubleshooting and Safe Replacement

Before assuming your condenser fan motor has failed, test the capacitor. A fan that hums but will not spin is often caused by a bad capacitor, not a bad motor. A capacitor costs less, so check it first.

A new motor often needs a new capacitor rated for it. When you replace the motor, follow these general steps to complete the repair safely:

1. Shut off power at the household breaker panel and pull the outdoor disconnect plug.
2. Test with a meter to verify no electrical power reaches the outdoor unit.
3. Safely discharge the capacitor using an insulated tool before touching any wiring.
4. Take a clear photo of every wire connection before loosening any screws or pulling terminals.
5. Unbolt the fan blade assembly and remove the old motor from its mounting frame.
6. Mount the replacement motor securely and transfer each wire one at a time to the matching location shown in your photo.

Read your old part

1. Look at the metal data plate attached to the housing of your existing outdoor motor.
2. Clean off any dirt or grease to locate the printed manufacturer part number.
3. Check that the part number reads 1080612.
4. Confirm the specifications on your old motor label match 1/8 HP, 208-230 Vac, 1120 RPM, and Counterclockwise (CCW) rotation.